Do you sometimes have difficulty deciding which side of the DSP to show? I know that I do! Well, this fun card allows you to show off both sides. With one sheet of 12 x 12, you can easily make six cards with little waste. Let me show you.
Products used can be purchased through my Stampin’ Up! on-line store, unless otherwise stated. You can find my website information under SHOP.
Don’t forget to subscribe to my blog by entering your email address located on the right side of my home page. I hope you like this card. Please feel free to leave a comment if you do (located on left side of page).
You can contact me at stampingnonostyle@gmail.com if you have any questions or in need of a catalog. I would love to be your Stampin’ Up! Demonstrator.
Happy Stamping,
Teresa (AKA “NoNo” by my Grandchildren)
Supplies:
- Stamps: Peaceful Deer #156891
- Punch: Deer Builder #156390
- Cardstock: Basic White, Sahara Sand, Basic Black
- DSP: Peaceful Prints, Be Dazzling
- Embossing Folder: Wintry 3D #155433
- Stampin’ Ink Pad: Memento, Sahara Sand
- Cut & Emboss Machine #149653
- Adhesive of choice, glue dots #103683 and Stampin’ Up! Dimensionals #104430
- Embellishment: Black & White Gingham #156485
Cutting Instructions (measurements in inches):
- Card base: 5 ½ x 8 ½, score at 4 ¼, then cut off a 3 ¼ piece which can be used to make a mat if you don’t want to use Basic Black.
- DSP, 4 x 5 ½
- Be Dazzling, ½ x 5 ½
- Basic Black, 3 ¼ x 4 ¼
- Basic White, 3 x 4
- Ribbon, approximately 6 inches, enough to tie a knot
Instructions:
- Prepare card base by folding the card in half at the scored mark, set aside.
- Stamp the sentiment with Memento towards the bottom on Basic White.
- Stamp the snow with Sahara Sand going across the Basic White, set aside to dry.
- Using the Deer Builder punch, punch out the deer from the Peaceful Prints DSP.
- Using the Cut & Emboss machine and emboss the flap of the card base using Wintry 3D folder.
- Adhere the Be Dazzling strip to the flap showing a little of this paper. Recommend using liquid glue or tear & tape because of the texture of this paper.
- Adhere the DSP to the front of the flap.
- Adhere the punched out deer to the Basic White just above the stamped sentiment.
- Adhere the Basic White to Basic Black and wrap around the ribbon and tie a knot.
- Adhere it to the card base using dimensionals.
Stamping NoNo Style 